$2,450 · Micro-Hydro turbine with Controller & water valves.
This Micro-Hydro system has never been used although it was purchase a few years ago. I am selling it on be-half of the new owner as it came from a deceased estate.
1: Mainland Micro-Hydro Turbine - standard single nozzle unit, with two nozzles choices and special spanner. The small grey electric box (on the side) has the three output generator wires. Comes with the owner's manual and Mainlands two-page description and specifications.
Alternator: Brushless direct drive.
Rotor: Corrosion resistant steel housing.
Bearings: Lifetime lubricated, multi-seal ball bearings.
Size: 510mm x 510mm x 400mm high.
Operating speed: 300-3000rpm.
2: Trace/Xantrex C35 Diversion load controller 12 or 24volt system with adjustable Bulk and Float charging voltages plus the owner's manual.
3: A purpose built mounting board with a diversion load resister, a plastic electric box that has a 3 phase rectifier mounted on the heat-sink on the top with a built-in Amp meter and inside a 3 x wire connector and at the right side the Xantrex load controller.
4: Other items.
3 x Water valves one with a pressure gauge
1 x T joiner
3 x Pipe joiners
2 x threaded pipe joiners
1 x Threaded joiner
1 x Metal electrical box with clear small window, size 400mm x 400mm x 165 deep
A 40 page document (EECA) on small hydro systems.
Estimated new price is over $6,000
Some long lengths of polyethylene pipe are available but you would have dig them out of the ground and do all of this at Queenstown!
|Details||Last hour:||Last 24 hours:||All:|
|Posted||April 12, 2018|
|Expiry||October 09, 2018|